Difference between revisions of "Locator Tutorial: Setting up Locator to work with UR robots"
Line 26: | Line 26: | ||
− | Amend the IP address and Subnet Mask to match the network configuration of the Locator Vision Controller: | + | Amend the IP address and Subnet Mask to match the network configuration of the Locator Vision Controller and click '''Apply''': |
− | [[File: Locator Setting Up Guide IP Config 3.png]] | + | [[File: Locator Setting Up Guide IP Config 4.png]] |
+ | |||
+ | |||
+ | == 3. Locator UR Cap Setup == | ||
+ | |||
+ | The Locator UR Interface is available as an URCap and three basic program templates. All of these files need to be copied to the Robot Controller. | ||
+ | |||
+ | As the first step, URCap needs to be installed. Extract the Locator URCap archive (.zip file) to the USB stick and plug it into the Teach Pendant. | ||
+ | |||
+ | Press '''Menu''' -> '''System''' -> '''URCaps''': | ||
+ | |||
+ | |||
+ | [[File: Locator Setting Up Guide IP URCap Install 2.png]] | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | [[File: Locator Setting Up Guide IP URCap Install 3.png]] | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | [[File: Locator Setting Up Guide IP URCap Install 4.png]] |
Revision as of 08:09, 17 January 2019
Users are strongly recommended to read Locator Tutorial: Introduction prior to installation of specific robot interface
Contents
1. Prerequisites
Prior to setup, please ensure that your UR controller meets the following criteria:
- CB3.1 or E-series Controller
- System version 3.2 and higher
Click Menu -> About to verify your controller System Version (see figure below):
2. UR Controller Setup
2.1 Set IP Address of Ethernet Port
The first step of the process is to configure the IP address of the Robot Controller.
Using the Teach Pendant, press Menu -> System -> Network:
Amend the IP address and Subnet Mask to match the network configuration of the Locator Vision Controller and click Apply:
3. Locator UR Cap Setup
The Locator UR Interface is available as an URCap and three basic program templates. All of these files need to be copied to the Robot Controller.
As the first step, URCap needs to be installed. Extract the Locator URCap archive (.zip file) to the USB stick and plug it into the Teach Pendant.
Press Menu -> System -> URCaps: