Difference between revisions of "Locator Tutorial: Setting up Locator to work with UR robots"
From 3D scanning Knowledge base - Photoneo wiki
(Created page with "Placeholder") |
|||
Line 1: | Line 1: | ||
− | + | '''Users are strongly recommended to read [http://wiki.photoneo.com/index.php/Locator_Tutorial:_Introduction Locator Tutorial: Introduction] prior to installation of specific robot interface''' | |
+ | |||
+ | == 1. Prerequisites == | ||
+ | |||
+ | Prior to setup, please ensure that your UR controller meets the following criteria: | ||
+ | |||
+ | - '''CB3.1 or E-series Controller''' | ||
+ | |||
+ | - '''System version 3.2 and higher''' | ||
+ | |||
+ | Click '''Menu''' -> '''About''' to verify that the your controller meets the prerequisites (see figure below): | ||
+ | |||
+ | [[File: Locator Setting Up Guide About.png]] |
Revision as of 07:10, 17 January 2019
Users are strongly recommended to read Locator Tutorial: Introduction prior to installation of specific robot interface
1. Prerequisites
Prior to setup, please ensure that your UR controller meets the following criteria:
- CB3.1 or E-series Controller
- System version 3.2 and higher
Click Menu -> About to verify that the your controller meets the prerequisites (see figure below):