Difference between revisions of "Upgrading firmware"

From 3D scanning Knowledge base - Photoneo wiki
Jump to: navigation, search
(Created page with "= Upgrading firmware on your scanner == This method only works with PhoXiControl release candidate v1.2.3 or higher and with scanner firmware v1.1.62 or higher. DO NOT USE THI...")
 
(Upgrading firmware on your scanner =)
Line 1: Line 1:
= Upgrading firmware on your scanner ==
+
== Upgrading firmware on your scanner ==
 
This method only works with PhoXiControl release candidate v1.2.3 or higher and with scanner firmware v1.1.62 or higher. DO NOT USE THIS GUIDE, if your firmware version is lower than v1.1.62 (If you would like to upgrade firmware lower than v1.1.62 contact us at support@photoneo.com)
 
This method only works with PhoXiControl release candidate v1.2.3 or higher and with scanner firmware v1.1.62 or higher. DO NOT USE THIS GUIDE, if your firmware version is lower than v1.1.62 (If you would like to upgrade firmware lower than v1.1.62 contact us at support@photoneo.com)
  

Revision as of 07:40, 7 September 2018

Upgrading firmware on your scanner

This method only works with PhoXiControl release candidate v1.2.3 or higher and with scanner firmware v1.1.62 or higher. DO NOT USE THIS GUIDE, if your firmware version is lower than v1.1.62 (If you would like to upgrade firmware lower than v1.1.62 contact us at support@photoneo.com)

1) Contact us at support@photoneo.com and we will provide you with a .deb file, this is the installer for the firmware.
2) Open PhoXiControl and connect to the scanner you want upgrade your firmware on.
3)