Bin Picking Tutorial: Setting up Photoneo Bin Picking Studio with MITSUBISHI robots
From 3D scanning Knowledge base - Photoneo wiki
Revision as of 13:42, 6 March 2019 by Durovsky (talk | contribs) (Created page with "'''NOTE: Users are strongly recommended to read the [http://wiki.photoneo.com/index.php/Binpicking_Tutorial:_Introduction_to_Robot_Interfaces general introduction to robot i...")
NOTE: Users are strongly recommended to read the general introduction to robot interfaces prior to installing specific robot modules.
Contents
1. Prerequisites
Photoneo Mitsubishi Interface is written in MELFA V language and it has been tested on following controllers:
- - CR750D
- - CR800
The development has been performed using RV2-FR Robot and CR800 controller with following system version:
2. Mitsubishi Controller Setup
2.1 Set IP Address
[[File: ]]
[[File: ]]
[[File: ]]