Difference between revisions of "Bin Picking Tutorial: Setting up Photoneo Bin Picking Studio with ABB robots"
From 3D scanning Knowledge base - Photoneo wiki
(Created page with "ToDo") |
|||
| Line 1: | Line 1: | ||
| + | == 1. Prerequisities == | ||
| + | |||
| + | Following conditions must be met: | ||
| + | |||
| + | - '''(616-6) PC Interface Module''' available | ||
| + | - '''(672-1) Multitasking Module''' available | ||
| + | - '''RoboTWareOS 5.13''' and higher | ||
| + | |||
| + | == 2. ABB Controller setup == | ||
| + | |||
| + | === 2.1 Set an IP address === | ||
| + | |||
ToDo | ToDo | ||
Revision as of 21:30, 24 December 2017
1. Prerequisities
Following conditions must be met:
- (616-6) PC Interface Module available - (672-1) Multitasking Module available - RoboTWareOS 5.13 and higher
2. ABB Controller setup
2.1 Set an IP address
ToDo
